Audio path from codec2 to speaker is now set up only when an incoming stream
with matching CAN and destination callsign is received. Speaker is then turned
off when the demodulator goes back in unlocked state.
GD77 and DM-1801 already have an hardware low-pass filter on the battery measurement
probe which causes the low battery protection to trigger at boot if the digital low
pass filter is also used. Given that the hardware one is good enough for our purposes,
the digital filter is now excluded.
Provides a fix for #221
Removed an old workaround for an hardware bug of Module17 rev 0.1b limiting
the output swing of baseband signal in newer hardware revisions.
Contribution by Mathis Schmieder DB9MAT.
This will swap the first extended callsign with the source callsign
if there is extended callsign data.
This allows to always store the true source in the M17_src variable
See #188
Add west manifest contributed by edgetriggered to allow automated
cloning of the correst Zephyr revision.
Now codec2 dependency is enabled also for T-TWR build, enabling to build
it from scratch without first building a Miosix target.
Enabled non-cross build to use codec2 compiled sources.
We check if the battery is below minimum and, if so, assume that the charge
is 0%. This to prevent an underflow which would result in the function
returing a 100% charge level.
TODO: the include fixes can be probably refactored by including the
correct zephyr directories, as include/zephyr/posix/pthread.h should
already bringing in those header files.
TG-553
Replaced KEY_F7 and KEY_F8 with KEY_VOLUP and KEY_VOLDOWN.
Remapped the T-TWR Plus volume up and down keys to those, fixing a bug
in the pmu key detection where the wrong active edge was selected.
Adapt soft volume code for the UV3x0 to control code in the T-TWR Plus
by acting on the AT1846s Rx gain.
For target T-TWR Plus bound long press of KEY_VOLDOWN to macro menu open.
Unbound KNOB_LEFT and KNOB_RIGHT to squelch control and bound
instead KEY_VOLUP and KEY_VOLDOWN.
TG-553
T-TWR Plus appears to have sever voltage drops during normal operation,
therefore we cannot use OpenRTX's low voltage warning screen on this
radio.
TG-553
The bug was due to an uninitialized memory being used to configure the
RTX thread, that disabled Tx in a random way by randomly set the
txDisable field.
TG-553
When a new dst callsign is set, the rtx configuration data structure is
updated and this may trigger false setting of the lsfOk variable to true,
causing the M17 info screen to appear for a very small, but noticeable,
amount of time.
Silvano Seva
Morgan Diepart
marco
Niccolò Izzo
tarxvf