Enabling SMBus timeout in the capacitive touch sensor and not in the MCU would cause the CTS to reset and the MCU expecting the transaction to keep going, locking-up the device.
Timeout should be re-enabled when SMBus will be implemented.
Module17 uses an OLED display, which does not have contrast regulation. The
contrast control register, however, allows to change the brightness of the
display.
Reorganized code for pixel framebuffer in order to have it instantiated once
and for all the possible display drivers. Dropped the display_getFrameBuffer()
function.
Switched to int32_t for RSSI representation to allow running the code also
on devices with limited resources. Defined a new ad-hoc type to still keep
the possibility of using floating points on more capable devices.
General code optimization allowing to reduce the overall binary size, especially
for devices without hardware floating point support. On the MD-380 (which has the
FPU) the .text size has been reduced of 4'928 bytes.
The "revisions since last tag" version field is now accurately named and no longer checked. Extra parentheses also added to reduce compiler warnings.
Fix#217
Removed an old workaround for an hardware bug of Module17 rev 0.1b limiting
the output swing of baseband signal in newer hardware revisions.
Contribution by Mathis Schmieder DB9MAT.
Fixed error in compuation of values for AT1846S frequency registers
causing the output frequency to have an effective resolution of 1kHz
instead of 62.5Hz.
On LILYGO T-TWR Plus the squelch was being controlled by AT1846s,
resulting in the squelch bar setting being completely ignored. Now we
are introducing the support for a new command of sa8x8-fw called
AT+AUDIO that controls the muting or unmuting of the speaker power
amplifier, enabling us to:
1. Disable AT1846s embedded squelch
2. Enable OpeRTX squelch
Also fixed a bug where the sa8x8-fw version was incorrectly checked.
AT+AUDIO requires sa8x8-fw version v1.3.0.r1, bumped version check in
OpenRTX.
TG-553