This change improves the `rad clone` command in a few different ways.
The first improvement is to check if the repository already exists before
fetching. If it does exist, then there is no need for the fetch to be performed,
and can move straight to the checkout.
If the repository does not exist, then the fetch is performed, as per usual.
However, it uses a replication factor of 1, so that the fetch finishes as soon
as it has the repository in local storage.
The change also improves the output when failures occur while attempting to
perform the checkout phase. It will print the failure that occurred and provide
a hint message in each case to help debug the failure, or push the caller in the
direction of performing the correct action.
This required some changes in `test/commands.rs` setup. Some tests were using
the `rad-clone.md` to setup a clone, which would have different output if the
repository did not need to be fetched. In those cases, the `rad` method for
performing the clone is used instead.
This patch changes separates the business logic of fetching from the process of
fetching itself. It does this through a sans-IO approach, where a `Fetcher`
provides the necessary state to help drive a fetch forward, without performing
any of the IO itself.
What the `Fetcher` cares about is:
- What nodes are going to be attempted to be fetched from
- In what order should they be attempted
- When should the fetching process be considered finished
The `Fetcher` is then used in `radicle-cli` to drive forward the `sync::fetch`
function, allowing it to only care about the IO.
* Remove `rad sync --force` flag
* Remove `rad clone --private` flag
These flags are no longer necessary. Simplify specifying which seed
to fetch from with `--seed` is enough.
The command now works with both a replica target *and* a seeds target.
This is especially useful to eg. ensure that a preferred seed has been
synced, while still trying to hit a higher replica count.
We were using the two pretty interchangeably. "Project" should only be
used to refer to the repository payload. "Repository" should be used
when referring to the resource that is fetched, synced, cloned, checked
out etc.
Since forking creates your `rad/sigrefs`, which then needs to be backed
up forever, we avoid forking on `rad clone`. This should make little or
no difference for users, as the "fork" will be created on `git push`.
After cloning, we show a cool little summary with some repo stats.
We had to make some adjustments to the way visual width is calculated
due to a bug surfaced around emoji width calculation. Unfortunately
there isn't a perfect solution that works across terminals yet, so the
"variation selector 16" code-point is filtered out for now.
This adds functionality so that on `rad sync` and `rad clone`, we
connect to known seeds if necessary, before attempting to fetch.
In passing, some related changes were made:
* The `rad sync` command's arguments were reworked:
`--replicas <count>` can be used to specify a replica count when
fetching
* The `rad patch` command no longer has a `--fetch` option
* It's now possible to tell the node not to automatically connect to
peers in the background
* `AddressBook` is being used underneath `Seeds` to allow for shuffled
iteration
Lorenz Leutgeb
Fintan Halpenny
Lorenz Leutgeb
cloudhead